Water Change Calculator

Find out how much water to replace and how it affects your aquarium.

Use my aquarium

Use actual water volume if known.

30% is a starting example.

See how your water values change Nitrate, phosphate and water hardness

New water is the water you add during the change.

Advanced units

Choose the unit on each report before entering its reading. Switching units converts any value already entered. Results and targets use mg/L as NO₃.

Advanced calculations

Reach a target

Use the aquarium and new water readings above to find a change amount for your target.

Repeated water changes

Use the same change percentage and new water for every step.

What a water change actually changes

A water change removes some of the dissolved material in the tank and adds what is in the replacement water. If the aquarium starts at 40 mg/L nitrate and the new water contains 5 mg/L, a 30% change leaves about 29.5 mg/L. A replacement source with a higher concentration can raise the aquarium reading.

Use the water volume, not the tank's label

Substrate, hardscape and the space above the waterline reduce the water an aquarium holds. Use the Aquarium Volume Calculator if you need an estimate.

Repeated changes and real aquarium conditions

Every partial change after the first removes some of the replacement water from earlier changes. The calculation assumes equal amounts removed and replaced, complete mixing, and unchanged source water. Active substrate, rock, plant uptake, waste and dosing can change what you actually measure. Rapid changes in water chemistry or temperature can stress livestock.

Need softer replacement water? Plan a tap and RO mix · Planning fertilizer doses too?

Water change schedule · Aquarium water parameters guide

Scroll to Top

Report an Issue

Only this report and the page location are sent. Please leave out passwords and other sensitive information.