RO Water Mixing Calculator

Find out how much tap water and reverse osmosis (RO) water to mix for your target hardness.

Use your measured readings. Enter 0 only if your test shows zero.

Check the other hardness Optional · Estimate KH from the same mix

GH is general hardness. KH is carbonate hardness. Your first target sets the ratio. Use these readings to estimate the other hardness.

Mixing tap water and RO water

Two water sources can produce any hardness between their readings. The batch volume sets how much of each source to measure out. Test both sources, because RO water can still have measurable hardness.

Read the aquarium water guide

GH, KH and one mixing ratio

GH describes general hardness, mainly from calcium and magnesium. Aquarium KH tests measure alkalinity. One mixing ratio can reach your chosen GH or KH, while the other value follows from the same ratio. The pH of the blend cannot be predicted by averaging the source pH readings.

Before using this water

Check that your sources are suitable. Treat tap water for chlorine or chloramine where required. Test the prepared batch, compare its temperature and chemistry with your aquarium’s needs, and add it carefully. GH alone cannot tell you how much calcium or magnesium is present.

Water changes and evaporation

A water change removes aquarium water and the substances dissolved in it. Most of those substances stay behind when water evaporates, so a top-off is a different operation.

See how a water change would affect your aquarium · Aquarium Calcium & Magnesium Calculator

Scroll to Top

Report an Issue

Only this report and the page location are sent. Please leave out passwords and other sensitive information.